TN Appliance·Ant Call or text · 1-888-268-8998

LG Washer Leaking Water?

Answered by Teddy Pivacek, owner & lead technician at TN Appliance Exchange — repairing appliances since 2012.

Quick answer: An LG washer leaking water most often has a worn or torn door boot seal (front-loaders) or a leaking water inlet valve where the hoses connect at the back. Those two are the repeat findings in our own LG washer repair reports. After that our technicians have traced LG leaks to the detergent dispenser and receiver box, and to a tub that shakes hard in spin because the counterweight bolts worked loose or the shock absorbers wore out.
An LG washer leaking water most often has a worn or torn door boot seal (front-loaders) or a leaking water inlet valve where the hoses connect at the back. Those two are the repeat findings in our own LG washer repair reports. After that our technicians have traced LG leaks to the detergent dispenser and receiver box, and to a tub that shakes hard in spin because the counterweight bolts worked loose or the shock absorbers wore out.
The known LG issue: On LG front-load washers, check the door boot seal first: pull back the rubber fold and look for a tear. If the water shows up at the back instead, watch the inlet valve while the washer fills. Those two cover most of the LG leaks our technicians see.

What's actually different about a LG

Worn or torn door boot seal (front-load) Pro

The rubber boot around the door seals the tub. When it tears or wears out, water runs out the front during the wash, and it can drip down onto the drain pump below. Our technicians have found LG door boots that no longer let the door seal tightly, and one with a big tear.
What you can check: Open the door and pull back the fold of the rubber seal all the way around. Look for tears, holes or stuck-on gunk, and wipe it clean. A small object (a coin or bra wire) can cut it. A torn boot has to be replaced; that is a technician job on most models.

Leaking water inlet valve or fill hoses Moderate

The inlet valve at the back lets hot and cold water in. A cracked valve or a leaking solenoid drips every time the washer fills, even when it is off if the faucets stay open. Several of our LG leak calls came down to the inlet valve.
What you can check: Pull the washer out and look at the back while it fills. Tighten loose hose ends by hand, and replace a hose that is bulging or cracked. If the drip is from the valve itself, turn the faucets off between loads and call a technician.

Detergent dispenser drawer or receiver box Easy

Too much detergent, the wrong (non-HE) detergent or a clogged drawer makes water and suds overflow out of the dispenser area during the wash.
What you can check: Use HE detergent only, and less than you think. Pull the drawer out, rinse it, and clear the openings behind it. If it still leaks from the top front during fill, the receiver box behind the drawer needs a technician.

Tub shaking hard in spin (loose counterweight or worn shocks) Pro

When the counterweight bolts work loose or the shock absorbers wear out, the tub slams around in spin. Water can splash out and the washer may stop with an error. Our technicians have found both on LG front-loaders that came in as leaks.
What you can check: Make sure the washer is level and the load is even. If it bangs and shakes hard every spin, stop using it and have a technician tighten the counterweight or replace the shocks.

Drain pump filter cap or drain hose Easy

A cap that wasn't closed tight after cleaning the pump filter, or a drain hose that slipped out of the standpipe, leaves water on the floor.
What you can check: Check that the pump filter cap behind the lower-front panel is screwed in fully, and that the drain hose is secured in the standpipe.
Try this first: A reset won't stop a leak. Turn off the water faucets, unplug the washer, and wipe up the water. Then run a short rinse with the door open slightly ajar on a towel so you can see where the water first appears.

Get the exact LG part — shipped to your door

With the $50 Quick Check, send a short video and a photo of your LG washer's model number. A real technician confirms the diagnosis and we ship you the exact part with instructions — the $50 is credited toward it. Or we walk you through the fix free.

How this failure works on any washer

A leaking washer needs attention fast — laundry-room water damage gets expensive quickly. The good news is most leaks trace to a handful of spots, and several are things you can check or prevent yourself. The first job is figuring out WHERE the water is coming from, because that points straight at the cause.

Safety first: Unplug the washer and shut off both water valves before checking hoses or connections, and mop up standing water so you don't slip. If the leak is behind the machine, don't reach into a wet outlet area.

Worn or loose fill hoses Easy

The rubber inlet hoses at the back crack and blister with age — they're a leading cause of laundry-room floods, especially the ones more than 3–5 years old. A loose connection at the valve or washer also drips.
What you can check: Check both hoses for bulges, cracks, or dampness at the fittings and snug the connections. If the rubber is old, replace them (braided stainless hoses last far longer) — this is cheap insurance we handle on almost any visit.

Too much detergent / oversudsing Easy

Using regular (non-HE) detergent or too much of it in a high-efficiency washer creates excess suds that overflow and look exactly like a leak. It's one of the most common "leaks" that isn't a broken part.
What you can check: Switch to HE detergent and use only the recommended small amount. Run a rinse-only cycle to clear existing suds.

Torn door boot / gasket (front-load) Moderate

The rubber bellows around a front-load door catches coins and hair, then tears or molds, letting water spray out the front during the wash.
What you can check: Inspect the folds of the gasket for tears, debris, or a bent spring; wipe it out. A torn boot is a tech replacement.

Loose or clogged drain hose Moderate

If the drain hose isn't secured in the standpipe, or it clogs and backs up, water can push out during the drain/spin — usually a leak that only shows up at the end of the cycle.
What you can check: Make sure the drain hose is pushed in and secured at the standpipe and not kinked. A clog in the pump or hose is a tech job.

Failed tub seal or pump Moderate

The pump, its hose clamps, or the main tub seal can leak from underneath — you'll see water pooling under the center of the machine rather than at the hoses.
What you can check: Water under the middle of the washer points inside — that's a tech diagnosis and repair.

Is it worth repairing?

Almost always repair. Hoses, gaskets, and pump clamps are affordable, and stopping a leak protects your floors and the room below. Replacement only comes up if an old machine has a major tub-seal failure stacked with other problems.

Frequently asked questions

Why is my LG washer leaking water?

An LG washer leaking water most often has a worn or torn door boot seal (front-loaders) or a leaking water inlet valve where the hoses connect at the back. Those two are the repeat findings in our own LG washer repair reports. After that our technicians have traced LG leaks to the detergent dispenser and receiver box, and to a tub that shakes hard in spin because the counterweight bolts worked loose or the shock absorbers wore out.

What's the known issue to check first on a LG washer that is leaking water?

On LG front-load washers, check the door boot seal first: pull back the rubber fold and look for a tear. If the water shows up at the back instead, watch the inlet valve while the washer fills. Those two cover most of the LG leaks our technicians see.

Why is my washer leaking from the bottom?

Water pooling under the center usually means an internal leak — the pump, a hose clamp, or the tub seal. Water at the back points at the fill hoses; water at the front of a front-loader points at the door boot. Where it pools tells us the cause.

Should I replace my washer hoses?

Yes — rubber fill hoses should be replaced every 3–5 years because a burst hose is one of the top causes of home water damage. Braided stainless hoses last much longer. We can swap them on almost any service visit.

How much does it cost to fix a leaking washer?

Often it's a low-cost hose or gasket; a pump or tub-seal repair runs more. Your $50 Quick Check credits toward the repair, and we check the whole water path so it doesn't leak again from a spot we missed.

Other LG & brand guides

All Washer Repair » Samsung washer LG washer Whirlpool washer GE washer Samsung washer Samsung washer LG washer Whirlpool washer All washers leaking water